SEAT · Diesel
Altea XL
2.0 TDI - 170-BHP - 127-KW
100/100 data completenessCanonical technical profile
ECU PROFILESIEMENS PPD1.xx(01/2006 - 01/2009)
INTERACTIVE DYNO PROJECTION
OEM to calibrated output.
These figures are database projections. The exact safe target is confirmed from the original file, software version, fuel, hardware and vehicle condition.
OEM170 hp
Stage 1205 hp
Stage 2226 hp
ECU ACCESS INTELLIGENCE
Programming context for this profile.
Tool support and access notes are imported from the supplied vehicle dataset. Always verify the current tool protocol and help file before connecting or opening a control unit.
- ECU / TCU
- SIEMENS PPD1.xx
- Engine code
- BMN
- Job type
- Always OBD
- Power
- 126.8 kW
- Difficulty
- Easy
- OBD location
- Behind panel, side of steering wheel
- ECU location
- Under bonnet
- Opening note
KTAGBdm(MPC5xx) · 75
KESS V2OBD · 109
AutoTunerNot yet supported - Check tool
Magic X17OBD/Boot
CMDOBD/Boot/Bench
DATABASE-MATCHED CAPABILITIES
DPFEGRHot startDTC diagnosticsSpeed limiterSwirl flapLaunch control
Technical source note
DPF off requires DPF to be reset with diagnostics on originl software. Ensure all ash counters are reset. Write modified file, then drive the car for 20mins. The DPF WILL go out.
If DPF light present on dashboard post remap, then needs diagnostic work. No drilling but complete removal on Siemens PPD. Always check live data reading with VCDS (measuring blocks 067 and 075). DPF pressure needs to be way below 10 mbar on idle (ideally 1 mbar on idle). Ash counter resets on mod file only drop DPF ash counter to 20% hence it needs to be driven for 5 miles to go down to 0%. When it reach 15% DPF light goes off. Check all DPF pressure sensors working, and not giving false values from broken sensors.
Have this exact vehicle?Send the original read so an engineer can verify software compatibility and the final target.
Start secure request